The Reflow Oven Controller controls your reflow oven using the attached temperature sensors and does not require any modifications to the oven.
Conformance to specific time and temperature profiles is necessary in order to obtain the best results when soldering SMD components with solder paste.
The Reflow Kit Controller controls your solder oven to maintain compliance with specific time and temperature profiles and achieve optimal soldering results. To configure the controller parameters, you can connect the controller to a serial interface port on your PC.
The boards and components are heated gradually during the preheating phase. This avoids generating mechanical stresses in the board and the components.
After preheating, the temperature is briefly raised to just below the soldering temperature. This allows the volatile ingredients of the solder paste to escape without forming bubbles.
After this, the temperature is raised to the soldering temperature. The solder paste liquefies and bonds the components to the board. The soldering temperature is maintained precisely during the soldering time to prevent damage from overheating.
The controller emits an acoustic signal to mark the end of the soldering phase. The fully soldered boards can now be removed from the oven.
1 Reflow Controller for controlling your reflow oven
Technical data:
Temperature sensor with cable and connector
(placed in the oven along with the PCBs)
Fuse: 8A-T
Maximum rated load: 1,500 W (oven connected)
Operating voltage: 230 V / 50 Hz AC
Use only indoors in a dry area.
Suitable for use with any oven that does not exceed the maximum rated load.
Spare temperature sensor for Reflow Controller